A cover to go over the rear of the turret on the Skorpius Disintegrater so you no longer need to use the gunner. This will make it easier to change the vehicle version. I saw a picture of someone doing this and it looked pretty good. That might be an idea.Maybe I can cut up a ranger and fit it in. Makes it look a bit more Tank-y. Do you spend too much time browsing reddit? Does your family come to you to fix the internet? I have two of them assembled to the point where it's only the differences between the two kits left, and I have magnetized the most obvious things, but I'm struggling with how I'm going to handle the servitor for the turret/heavy stubbers. Still need to work on magnetizing the other weapons, for the one with the big hole in it I may glue a piece of sprue down in there so I can put a magnet on it. That’s what I did at least :). Turret Skorpius Desintegrator by Gotrekj is licensed under the Creative Commons - Attribution - Non-Commercial license. I have two of them assembled to the point where it's only the differences between the two kits left, and I have magnetized the most obvious things, but I'm struggling with how I'm going to handle the servitor for the turret/heavy stubbers. Press J to jump to the feed. I am going to use a spare Gunner from an Onager kit, fits perfectly. In addition to its flanking pair of cognis heavy stubbers, and prow-mounted disruptor missile launcher, the Skorpius Disintegrator bears a ferrumite cannon or a voltaic belleros energy cannon. I personally decided to go without the defensive plates and leave the poor servitor exposed. What I'm currently doing is keeping the servitor in the form that matches the disintegrator version and then magnatising the Stubber onto the piece that holds the main cannons, it might look a bit lop-sided however it's not really viable for me to magnatise just to fit a Stubber, I'd rather integrate it with the main gun but not sure if that would look stupid or not. Welcome all new and returning players to r/adeptusmechanicus, a subreddit where we discuss all things cult mechanicus and Skitarii legion (with some knights on the side), please look at our "admech resources" page before making a post and may the omnissiah bless you. Hello, so now the Skorpius kit has been out for a little while, price and usefulness aside, how are people converting between them? I cut off the nubs on the arms, glued magnets in their place, and drilled out holes on the stubbers to fit matching magnets in. I wish I had a spare gunner.Might look to try to get one second-hand. Its primary turret weapon is manned by a Servitor gunner that has been hard-wired into … Liked By View All Give a Shout Out If you print this Thing and display it … Press question mark to learn the rest of the keyboard shortcuts. Works with the original turret design just finished my kitbash with a spare datasmith will be posting it soon. Currently I'm thinking there are a few options: Leaving the servitor out of the turret, and only have the servitor as a heavy stubber slave. so now the Skorpius kit has been out for a little while, price and usefulness aside, how are people converting between them? Do you feel like a god when you open the microwave before it beeps? With a bit of wiggling you can can you the skiatari popping out the hatches to fit inside the turret on the disintegrator, then you can leave the servitor in the stunners. Going without the plates might be an idea.But I fairly fancy the look of the full turret. went a bit heavy on sawing and using greenstuff, New comments cannot be posted and votes cannot be cast, More posts from the AdeptusMechanicus community. I left the Servitor out of the turret and used some spare parts to fully enclose the tank turret. Find an alternative servitor and put into the turret, any tips on models to convert?